Most exterior and interior waterproofing companies offer services both inside and outside, but many homeowners don’t always know which option is right for their home. To determine what option is right for your home, it’s important to contact Basement Waterproofing Boston and learn the basics of both interior and exterior waterproofing.
Exterior waterproofing is a very common option for protecting your home from the weather. It can be done in two different ways – with a membrane or with a sump pump. Both are used to prevent flooding, but they do have their pros and cons. There are a few reasons why homeowners choose to use a sump pump to waterproof their home. Here’s a look at both options.
A sump pump is a device that sits on top of a foundation or driveway and removes water from your home by raising the water level inside the home. The sump pump is usually placed underground and is powered by electricity. This means that you need to have a power source for your sump pump. If you don’t have a power source, then a sump pump may not be the right waterproofing system for your home. So you’ll need to make sure your power company can provide you with an electrical supply.
If you’re installing a sump pump on your own, you’ll need to be careful when you pour the concrete mix and pour into your foundation or driveway. If you aren’t very careful, then the concrete mix may crack and damage your foundations or driveways. Also, if you pour concrete into your foundation or driveway that’s too deep, then it may not stay in place. That can cause some flooding, so you’ll want to use a sump pump that will allow you to pour concrete down to just above the depth that will allow it to stay in place.
Exterior waterproofing is usually done with a membrane or a polyurethane coating. Both of these methods work well, but there are pros and cons to using either method. Before you decide to use either type of waterproofing system, you should take a look at your home and consider how you want to waterproof your home.
Exterior waterproofing will typically involve sealing the foundation and driveway, and then you’ll add some kind of sealant to your exterior walls to prevent water from leaking outside. In addition, the exterior walls may be treated to keep out the sun, snow and rain. As a general rule, you don’t want to go overboard with the sealing process. If you apply too much, you’ll find that it does not provide as much protection as you thought. It’s best to leave it loose so that you can see if water does seep through your sump pump or on your exterior walls.
Also, if you have an internal water leak, then you’ll want to repair it before using exterior waterproofing to protect your home. You don’t want to risk the internal water leak seeping into the basement, crawl space or underneath your house during the installation of exterior waterproofing. The problem with some types of waterproofing is that it can cause internal water problems. If your house has plumbing, you’ll want to repair or replace pipes to prevent leaks.
If you use a sump pump to waterproof your home, you need to make sure that you check the exterior pump regularly to make sure it’s running properly. Check the fluid levels and make sure they are at a proper level before you use it again. The last thing you want to do is put too much pressure on the pump and end up damaging your house.